GW Rev 2.0.100 > Error config file

[iz1kbp]

2.0.100 give me the same error that I've during upgrade fron 2.0.80 to 2.0.95:
from 2.80 to 2.95 > I've copyed manually all data from old cfg file to the new one and afther that gw 2.0.95 seem to work in right manner (only don't transfer template file, like your post).
From 2.95 to 2.100 > the 2.95 cfg file don't work again,I must copy another time all data from old to new and now it work again...
However...the new rev lock up the system many time....
I've made upgrade like from your last 2.0.90 post (copy a to b and install over a)

Rev 2.0.80 work fine!

There is something wrong : in local , with all source file, it may be all fine, but not in remote (the compiled file)

Mario

[iz1kbp]

...may be...or not may be... is there some one who have the same problem?

Ciao a Tutti..

mario

[iz1kbp]

Hi Antoine,
Unfortunately your mail server stop my mail...err 500...
I've a problem with stylesheet created with GW rev 2.80 and imported in the never release.
So,I don't know why they do not work in new relase ( error >> Impossible d'ouvrir le fichier source).

simple1-gust.zip

I've attached one of my stylesheet.Could you say me if you found the same my problem?
If is true...Have you understand why?

thank's in advance

Mario

[TiToine]

Hi !

I can load your stylesheet...but I use the last revision 2.0.111, did you try it ?

[iz1kbp]

Yes, I've used rev 2.111 also...
But ... wath mean the error that I've report in last post (error >> Impossible d'ouvrir le fichier source)?

Mario

[TiToine]

GW can't read your source file. Check the plugin and source files in setup.

[iz1kbp]

question: why 2.80 read my stylesheet and 2.111 do not read the same stylesheet? the plugin is the same (I think...)
Wath is the routine that generate the error? perhaps in...lenght file?size file?...

Mario

[TiToine]

I can load your stylesheet. What is the error ? error >> Impossible d'ouvrir le fichier source ? this error concern the source file (history.dat), GW don't find it, not the stylesheet.

[iz1kbp]

Ok, now I've understand where is my ...target!
The problem was in the path of history.dat :I've copied my old config file (to avoid re-config all program) in the new directory but.... seems to be that not all data will be read ( the path is not read) from old cfg file.
May be normal?
However now I've set manually the data path and all works fine.

Mario