Probe Correction

[iz1kbp]

Hi Antoine, sorry for troubble but I don't understand wath's mean the above in obj.
I've seen that GW readout double value of rainfall than the station read out.
esample : 2.2 mm/h read on Ws station and about 4.4 read on 1h rainfall.(read a the same moment)
Do I correct the probe to obtain the same value?
I've tryed to correct with 0.5 (point) or 0,5(comma) but I haven't seen any variation on GW readout.
I've read the other post in forum but however I don't understand the method (sorry for ignorance
Is it a realtime correction or I must wait for a little time?wath is the right factor?

Ma be this problem bind with my readout rainfall error?

Thank's in advance for any answers you want and can!!

Mario

[TiToine]

Is it possible that you have put a factor 2 in probe correction before ? It could be explain your previous post.

So, go to Setup > Probes > Probes, and click on default filter, default correction buttons. Check if errors have disappeared.

[iz1kbp]

HI antoine,
Yes,I've got RESET all probe setting and filter...but nothing has changed.
Now all probe setup/filter are blanck, default setting.
Question : is the correction probe active only on the next data acquired or is it active on ALL data (past and next) ?
measure correct = AAA x Measure BBB wath's mean AAA and BBB ?
Wath kind of data for AAA and BBB must I insert to obtain (MYDATA FROM HISTORY)/2 ?

Thank's again and sorry for troubble.

Mario

[TiToine]

Hi,

The calibrations/filters are applied to the data read on history, so for all data.
AAA and BBB are calibrations factors. You need AAA=0.5 to divide by 2 your actual data.

[iz1kbp]

Ciao Antoine,
Thank's ... later I'll try

mario